Another Delphin Build with m60

[robiniscool]

Been a member on the forum for awhile so i figured i start thread on my build
I picked up this delphin


Drove the m20 for a couple weeks and figured it was time for a engine change so i picked up this bad boy with 90k miles


quickly went to replacing all the seals, gasket, guides and cleaning up the engine ready for installing

[jpod999]

Another 32v swap! I'm excited to see where you are in your swap.

[robiniscool]

Another 32v swap! I'm excited to see where you are in your swap.

I actually have all the parts ready to have this thing running but as with every swap I'm sure ill run into some problems

[robiniscool]

Decided to get a behr z3m radiator to keep it oem looking


also got a Tilton brake reservoir to make things cleaner for the manual brake setup. The best place to mount was near the battery tray



also got the revshift guibo for the 6 speed transmission flange

[robiniscool]

My goal for the swap was to get it legalized in CA so i modded the headers to look "Oem." It was a super tight squeeze but i figured with enough patience anything is possible ;D I used flaming river steering shaft pieces to get my the most space possible
heres pictures of the modded exhaust manifolds, everything was trimmed short to fit and everything was nice and tight on the car



The hardest part was the y pipe on both sides, it took awhile to make everything line up perfectly with clearance to put oem bolts easily

[robiniscool]

got the remote reservoir mounted on top of the cover and it fit perfectly to keep things and nice and neat



I also redid all the hard lines in the front to make things cleaner and installed a adjustable brake bias and i also got lucky that the valley pan cover only needed a cheap gasket rather than replacing the whole thing



With christmas just around the corner i did manage to mount the engine and I'm pretty satisfied on how it close i am to driving it around

[jpod999]

Feels good to get it dropped in that first time huh?