My e30 DTM car copy build
Collapse
X
-
-
Let's set this straight
bnumbners is NOT chicken wire boy.
Bnumbners = erick/rwdrift picking up myspace chicks
Chickenwire= some random toolbag with teh razors suspension.
teaguer: we got the joke on the first post :-*
and on the subject of reinforcing the rear shock mounts: I agree, it even lends the possiblity or running true rear coil overs down the road.
JulienComment
-
Since everyone knows im going to be running ap racing brakes a balance bar is needed. So im going to be running floor mount pedals too. AS bill stated no corner will be cut and I'm building everything to a very high standered
Right now im more concerned with getting the car built then dialed in. Once thats done i will do a DTM tubular trailing arm set up with adjustable rear roll center, and cockpiut adjustable sway bars. Then i will start building a bmw v8.Last edited by ///meric; 10-10-2007, 08:33 AM.I wanna go FastComment
-
Swing wild, brake later, don't apologize.'89 324d, '76 02, '98 318ti, '03 Z4, '07 MCS, '07 F800s - Bonafide BMW elitist prick.FYYFFComment
-
We use only the finest German hammers and blowtorches to bend tube.
The design of the cage looks decent (you obviously picked a good design to copy) but... work on your fabrication techniques. It's totally unacceptable to weld a tube straight to the chassis. (there are exceptions to this, but not where you did)
You probably shouldn't be using 4130 either...Comment
Comment