If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Ive been a super slacker the past 2 weeks , There was an east coast e34 meet i was trying to get my car ready for, then wrapping up my sisters car. I took today off so i can make some progress...
I'm in need of a steering rack and front half of an m20 standard driveshaft. Anyone have one?
After a few weeks of not doing much i finally got some work done today. I had been waiting for a steering rack before throwing the engine back in, big thanks to fredk and his e30 awesomeness!
For starters i welded two nuts into the bottom of the sub frame. This way i can make a skid plate that easily attaches to the sub frame and rad support.
After that I cut the spring perch on the front housings and welded one about an inch lower for more adjust-ability. Also i get more travel now that the adjuster is out of the way.
Once all the parts had dried i tossed the engine and suspension back in.
yes i painted the abs unit... one of the fittings is partially stripped so i didn't bother removing it.
And finally just for shits and gaggles i put the coils and bags all the way down. Its not very drivable but i find it entertaining
Stay tuned, theres not much more i need in terms of parts so progress should stay steady :grin:
I finished the passenger corner of the cab last night.
Then on to the bed rails... No more C-pillars!!
After that i decided to dabble with the lower point of the new B-pillar
And thats all for tonight. Big thanks to some vdub guys who came and helped out. Portions of the drivers side are solid just not ground yet (my last grinder disk died)
Comment