If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I think it's just decoration. Maybe in a car museum or something. You can't build a sink like that with the drain that high, you would normally machine something like that down... If it is real, it's dumb. Real dumb.
Yeah i don't see any drain holes in the pump, so got to be decoration.
I was thinking there might be smaller drain holes around the back side of that raised part where the drain is, maybe that back part of the bell housing sits lower back there. That would have been REALLY hard to machine that center part down flush to put a drain down in there, so maybe they did that.
Comment