Jongbloed 15x10 On Track Car

[GillesBigCowboy]

This is the ET15 wheel fit with no spacers?

[RoccoB517]

I don't think my 245 Hoosiers are stretched that much. I wonder if they are wider than the Maxxis'.

[robgoesvroom]

Jongbloed 15x10 On Track Car



car has not yet been corner balanced or aligned. Last time I had an alignment I was at -3* degrees of camber rear: Original rear bushings

Sent from my iPhone using Tapatalk

[LJ851]

I'd love to see a picture down the side of the car showing poke. How much flare do you think it would take to cover the tires? I bet some E46 flares with these wheels would look amazing.

[RoccoB517]

Spring rates, dampening, and ride height change it a bunch, though.

[RoccoB517]

I typically run:

Front
3.5 camber
0 toe
9.8 caster

Rear
2.5 camber
1/16 toe in

[Wh33lhop]

Usually like 3.5 with r comps with .5 less in the rear, if it's adjustable.

Can't make it but I'm keen on going back to buttonwillow. I drove a lemons race with kronus there once and never went back, it was quite a fun track.

[robgoesvroom]

Are you maxed out on camber?

No I have more to add. I'm going to get an alignment tomorrow and see where I'm at. Does anyone have recommendations for camber settings with R-comps?

Will try to make the speedsf event at Buttonwillow next weekend, wh33lhop you should come!




Sent from my iPhone using Tapatalk

[Wh33lhop]

Are you maxed out on camber?

[robgoesvroom]

From where I stand I'm very impressed. I would have needed much hammer to make them fit. The liners in the rear were rusted out badly, so cutting didnt really matter. Fine work!

Thanks sir, can't wait to see when you get your set all mounted up and tested! The car is sitting much higher than I would like at the moment and I'm not quite sure how much camber I'm running up front, but it's a hoot to drive

[RoccoB517]

Fits on stock body Are you not impressed?

Sent from my iPhone using Tapatalk

From where I stand I'm very impressed. I would have needed much hammer to make them fit. The liners in the rear were rusted out badly, so cutting didnt really matter. Fine work!

[FredK]

I found an amazing deal on 245/40r15 Hoosier R6's that I couldn't pass up. The good news is that I'll try 275's when these are finished, so then we'll have data and everyone can berate each other some more.

Niice!

That is a really meaty look.

In the garage with a heat gun and fender roller. No cutting! I still have that rubber shit that goes in between the fender lip because I forgot to scrape it off. No fender liner

Ooh ok, sick!

[robgoesvroom]

In the garage with a heat gun and fender roller. No cutting! I still have that rubber shit that goes in between the fender lip because I forgot to scrape it off. No fender liner


Sent from my iPhone using Tapatalk

[FredK]

Fits on stock body Are you not impressed?

Sent from my iPhone using Tapatalk

holy O_O

How did you modify your fenders? And what about the rear wheelwells, did you do any cutting / flaring?

[Wh33lhop]

Fits on stock body Are you not impressed?

Sent from my iPhone using Tapatalk

heeeells to the yes! that looks fantastic