E30 Non M Racer pic post

[SoloSol]

This one is my GF's e46 that I borrowed for a session. Yes that is her car.

[j0oftheworld]

Firebird West track in Phx, AZ
(w. a really fast E36M hunting me down) :D

[e30pq]

BMWCCA club race at Chuckwalla in March


Some fast E30's



The Sunday points race from the pace car

[brian52555]

OMG, last shot from the pace car is epic. Do you have a full size wallpaper version?

[e30pq]

OMG, last shot from the pace car is epic. Do you have a full size wallpaper version?

All of those photos are out here. The pace car photos are all the way toward the back of this album. You can download high res. The pace car photos are around page 25, 26 & 27.

http://s266.photobucket.com/albums/ii260/pquattro/2011-3-19%20BMWCCA%20Chuckwalla%20Valley%20Raceway/

[OhioriderAaron]

Here's a few from the NASA event at Mid-Ohio a few ago...I'm not very familiar with motorsports photography but these came out alright...great E30 turnout! :)

[OhioriderAaron]

[Eric]

Some shot from Chuckwalla Valley Raceway, the new race track in Southern California built on an old WWII airfield at Desert Center CA.

Nice looking track, I didn't think the hippies would allow a new track to be built in CA! They slammed the old Castle AFB track proposal up in Atwater until the company ran out of money and just quit.

Do you have any detail pictures of your rear wing uprights? I like the design of them. Where did you mount them in the trunk?

[e30pq]

Nice looking track, I didn't think the hippies would allow a new track to be built in CA! They slammed the old Castle AFB track proposal up in Atwater until the company ran out of money and just quit.

Do you have any detail pictures of your rear wing uprights? I like the design of them. Where did you mount them in the trunk?

I think I have a photo of the uprights after we picked them up from our machine shop and before powdercoat. Let me look for that one.

We mounted the uprights to the trunk floor with backing plates on the underside of the trunk floor. We also braced them at the top of the trunk. You could push the car from those uprights.

[Eric]

Do you happen to have the file the machine shop used?:nice:

[iflytii]

All of those photos are out here. The pace car photos are all the way toward the back of this album. You can download high res. The pace car photos are around page 25, 26 & 27.

http://s266.photobucket.com/albums/i...ley%20Raceway/

Thanks for sharing those!

BTW, those uprights look pretty swanky!

[gverelli]

Fresh from Speed Hunters' coverage of the Nurburgring 24hr.

How do I get a higher res of this one?

[Eric]

I think I have a photo of the uprights after we picked them up from our machine shop and before powdercoat. Let me look for that one.

We mounted the uprights to the trunk floor with backing plates on the underside of the trunk floor. We also braced them at the top of the trunk. You could push the car from those uprights.

oh, wow, that is much thicker than I was thinking. The wing I have has two mounting brackets, each with two holes that have a 1/4" gap. I was thinking of using 1/4" thick aluminum, but maybe that's too thin/flexible??? My wing will be about as high as yours (roofline) so that is plenty of height for flex to cause problems...

[adamtnyc]

Thank you for this thread.

Total boner time.

[kronus]

lemons counts, right? :D



it's fully pickup'd and in the late stages of an M30 swap now.