NOR-CAL General Chat.

[Thizzelle]

Been posting to this thread:

http://www.r3vlimited.com/board/showthread.php?p=4072030#post4072030

Anyone have an ECU I can borrow to test? Sounds like Thizzelle and I are asking the same thing...

yours is a M3? if so then they aren't the same.

[oliver.r]

dead in here today

[marines2060]

dead in here today

get back to work!

[Pantless Spency]

Yeah it is.


Planning a meet in Vacaville more info to come soon.

[oliver.r]

get back to work!

racecars done check themselves tony

[JinormusJ]

NOR-CAL General Chat.

So after driving my e30 for a solid week, every other car I drive feels like a dump truck

I sit so high :|

Planning a meet in Vacaville more info to come soon.

Come to the Roseville meets bruh

[Thizzelle]

http://live.ultramusicfestival.com/miami

[Pantless Spency]

Soooooo.

"M535is."


Euro 528i chassis with all the goodies swapped over from a wrecked m535is, dogleg tranny, high strung m30, brown dash, m logo sport seats in brown leather, hella headlights euro grills, m5 front bumper and valence, euro rear bumper (not m5 because rear ended in m535is) m5 rear spoiler.

Slick top no sunroof, car is alpineweiss.

$1500


Here's the setback.

Parked 5-6 years ago was running, now it doesn't run, he suggest a full fluid change and a new battery would get it going, but a full rebuild would be the better path.

Should I do it? I have the money just chillin, would rather have that car then the e21.

[oliver.r]

Invest the money into the e30 and have 1 nice car as opposed to 2 cars that are broken-ish

[Spaceman]

Have a question about euro smiley conversion on my '86 eta. On the driver side the low beam light (Mr. Smiley) extends into the engine bay and the plastic shield that divides the engine bay from the lights won't fit. So has anyone else who has done this conversion had this issue and what did you do???

[Ian Bowers]

NOR-CAL General Chat.

My S50 swap makes me want to stick a hot soldering iron in my eyeball. All of the wiring is good, but still won't start. Gonna go look for a red label 413 tomorrow at Pick-n-Pull and give that a shot. Ah well, atleast it's moving along. :( Been learning how to weld by doing up my exhaust, kind of fun!

[Pantless Spency]

nice work mr bowers.

[Ian Bowers]

Thanks dude. I'll take you for a ride in it when I finally make it out to Sonoma Drift. I am hoping to have it done before next friday, still have to block sand the car, spray it, put the new headliner in/glass, and y'know, make it run. :\

[Pantless Spency]

Thanks dude. I'll take you for a ride in it when I finally make it out to Sonoma Drift. I am hoping to have it done before next friday, still have to block sand the car, spray it, put the new headliner in/glass, and y'know, make it run. :\

nice! i cant wait.

[Thizzelle]

Have a question about euro smiley conversion on my '86 eta. On the driver side the low beam light (Mr. Smiley) extends into the engine bay and the plastic shield that divides the engine bay from the lights won't fit. So has anyone else who has done this conversion had this issue and what did you do???

you need ellipsoid light covers. they have a clearance for them