NOR-CAL General Chat.

[kronus]

I have excellent nipples. They have good shape and serve their purpose well.

they will serve their purpose well, yes

how would you like to receive your transmission? making any trips up here soon?

[kronus]

Values of e36m3 hit the bottom a few years ago and are going up now

i wish the value of my m3 was going up..

[Wanganstyle]

i wish the value of my m3 was going up..

Just park it 5 years

[kronus]

"250k mile e36 m3, ran when parked 5 years ago, $12000 firm"

[golde30]

^^Hahahahaha^^

[freeride53]

[NATOBOT]

cam. never move crank

Thanks a lot cabriolet I finally got it on. Maybe I can finally get my car on the road

[phreshkid]

i wish the value of my m3 was going up..

I'll make a special trip, just for you.


For Serious.

[JinormusJ]

"250k mile e36 m3, ran when parked 5 years ago, $12000 firm"

loooooool

[suruba]

"250k mile e36 m3, ran when parked 5 years ago, $12000 firm"

this may sadly some day very well be the case

Dave

[phreshkid]

My m3/4/5 just tipped over 235k today. Still runs ok, though I do think about rebuilding the motor soon here. Might have Igor at Catuned do it.

[Cabriolet]

Just moved offices to HP Labs.

[Zeshin]

Hey, anyone have a recommendation for a shop to replace the bearings and seals in my Getrag 260? Ideally looking for a place around San Jose or San Mateo…Thanks!

[decay]

last issue I needed a shop for, I went to a place near my work-

bimmers bmw service
800 el camino real
san carlos, ca
650-591-2474

shop rate is a little pricey, but i was happy with how they appreciated a modified car rather than the usual sideways look of "what the hell have you done here"

[Tinkerer007]

I went to a place out in West San Jose, they didn't want to repair my Getrag 265, so found a rebuilt one out of Oregon. Turned out it had a noisy center bearing.

My next one I took to Eric at Suspension Performance (they are across from Edge and next to Dinan) to replace synchros. (I haven't used this transmission yet.

My mechanic, Robert at Lazlo's AKA Euro Auto, has a friend in San Mateo that rebuilds manual transmissions.

Hey, anyone have a recommendation for a shop to replace the bearings and seals in my Getrag 260? Ideally looking for a place around San Jose or San Mateo…Thanks!