clutch pedal not coming all the way back up HELP

[mod_junkie]

my clutch seems to feel like it has no pressure and is not coming all the way back up ( I have to pull it up with my foot) its also making it hard to actually shift into a gear help I need to go to work in the morning!!

[glnr13]

clutch master and/or slave cylinder

[ToPLeSS(e30)FeinD]

probably low on clutch fluid, or you have a leak somewhere (or both). is the spring still on the back of the pedal? that should do most of the work.. is there fluid on your carpet under the pedal assembly?

[mod_junkie]

No fluids haven't checked the springs and Wtf is the clutch master at?

[ky0u]

clutch master and/or slave cylinder

Yes check this

No fluids haven't checked the springs and Wtf is the clutch master at?

It's located on the transmission bell housing. Attaches to these holes on the outside:

[daiku]

The clutch master cylinder is located basically below the brake pedal inbetween some metal, and goes through the firewall and connects to the clutch pedal on a black piston like thing.

The clutch slave cylinder is on the driver side of the tranny bell housing ontop of it.

Edit: This video should help you out a lot. http://www.youtube.com/watch?v=wdf--suwqw0

[ky0u]

The clutch master cylinder is located basically below the brake pedal inbetween some metal, and goes through the firewall and connects to the clutch pedal on a black piston like thing.

The clutch slave cylinder is on the driver side of the tranny bell housing ontop of it.

Oops yea, got them switched up

[ToPLeSS(e30)FeinD]

master is under the dashboard, attached to clutch pedal by that spring.. if that is leaking, its going onto your floor board or its going back into the reservoir, which means it wouldnt be working at all.. typically.

best case scenario there is air in the line between the master and the slave.. bleed it and your problem goes away.. worst case scenario your clutch disk is defective (or old)

[ToPLeSS(e30)FeinD]

if its effected by temperature its almost definitely the fluid. fluid condenses when it gets cold and isnt sufficient enough to push the slave far enough.. gets warm and expands, act normal

[mod_junkie]

The bracket holding the master cylinder broke apart causing it to pivot when pressed on.

[mod_junkie]

yay how dafuq do I fix that? LOL

[ToPLeSS(e30)FeinD]

hahaha.. or that.. weld it/replace it... but either way you have to take apart the peddle assembly

[mod_junkie]

Replace it with what? Is that like an actual part I can buy from AutoZone or some shit haha

[ToPLeSS(e30)FeinD]

junk yard. its the entire peddle box iirc. im not sure if the gas/brake are separate but from my understanding its all one piece.. and you have to replace the entire thing cause its all welded together

[ky0u]

Kinda off topic but does your cylinder say "fag" O.o