How real men remove subframe bushings

[iamsam]

How the heck do you guys get your bushings to burn like that? I've been torching mine for a while but to no avail.

we used a sawzall at first, it removed some of the rubber so that the flame could actually pass through from one side out the other.

[Bishop]

That's an option too. Sam, texted you

[E30 Wagen]

I drilled through the rubber as much as I could and just kept torching it. Once I was satisfied, I was able to knock the center out with a hammer. Now i've just got the outer sleeve to deal with.

[iamsam]

Yeah you do have to sawzall off the outer sleeve. Just run a cut down the inside length of the sleeve, use a flathead screwdriver to peel the sleeve away from the wall at the cut, then it should fall out.

[KenC]

Tool to remove and install the TABs was about $15... takes maybe 5 min per bushing removal and installation.

[E30 Wagen]

Tool to remove and install the TABs was about $15... takes maybe 5 min per bushing removal and installation.

Where do i get that? I'm going to be doing my TA bushings, too.

[TimR]

Damn, now i'm going to have to save old radiator hoses to set on fire while doing SF bushings. No smell during removal ? Thats like going to the drag races with nose and ear plugs. Couldn't you just fill the holes of the SF bushing with JB weld, insert a straw to relieve the trapped air and be done with it??

[TimR]

The tool looks like a long bolt with washers, a nut and a piece of pipe for the old bushing to slide into, Home Depot $15 tighting the bolt pushes the bushing into the trailing arm and pushing the old one into the pipe.