picked up a parts car up in canada today, ill be using the motor, turbo and tranny unless i get a good offer on the majority of it.. Ill post up some better pictures tomorrow with my camera but here is a quick list of some of the parts..
top end rebuild, head gasket done at the same time (used all OEM parts)
Upgraded ecu from e36 (403) ? m3 with piggy back tuned at miller performance
New lower km transmission installed used redline synthetic New transmission mounts (around 120,000km runs perfectly)
H and R coilovers with new strut tire mounting plates
Rear subframe reinforcement
New rear subframe bushings
Staggered e46 m3 rims (2 look perfect, one has a little rash and one curBBBEd badly )
E36 m3 sway bars
AEM tru boost gauge type controller
AEM wideband o2 gauge
E46 m3 clutch
GT3071R Garrett liquid cooled ball bearing turbo less than 100 miles
Ceramic coated cast treadstone bottom mount turbo manifold (wont crack)
Custom 3 inch stainless steel downpipe
Custom 3 inch stainless steel exhaust
New catalytic converter (installed about 1000km ago)
38 mm external wastegate
Reinforced intake manifold
Stainless steel charge piping
Precision front mount intercooler
Recirculated Blow off valve
braided stainless steel brake lines
smoked tail lights
2 way car alarm.
i copied and pasted what he sent me in the listing, it has a lot of good parts.. either looking to put the motor in my e34, buy a e36 roller or sell it to someone who wants to do a e30 m50t.. not sure if the bottom mount would work in a e30 or not but its a very clean setup and it runs perfect! starts right up and idles steady even cold. 310whp, dyno sheets and tons of receipts. the front mount is taken off in the picture so i could get it on the trailor. let me know if anyone has a good e36 roller or interest in some of these parts..
Comment