S50! Guess what!

[Den_k321]

He said drop it like its hot... so Dan twisted the lift to drop it like its hot... outcome:

[ THESE ARE NOT THE SAME GUYS WHO WERE TAKING THE LSD OFF] lol

[Den_k321]

[Den_k321]

Here we go:

[Den_k321]

Here is my Engine on the Lift, not sure about the HP, will have to do DYNO it!

[Den_k321]

how was the old motor?

It was very good, have video and stuff, but ran like a champ!!

[2mAn]

how was the old motor?

[Den_k321]

If you're staying with the oem steering rack then you have I keep them. A lot of people swap it out for the e36 m3 steering rack or IIRC a z3 steering rack. It's a nice and easy upgrade and decently cheap if you can find one at the junk yards. And you can get the necessary spacers for the steering rack swap on e30tech.com

It is a 95 m3 steering rack, and I have all the spacers :)

Just looking at most of ppls steering racks I don't see those tubes, but I'm putting s50 in so maybe I should keep them and hope they clear the oilpan..

[eurotrash]

hes got both the e36 rack and the e30tech hardware

[SwiftE30]

Does anyone know if i have to remove those bigger aluminum tubes in front of the steering rack?

If you're staying with the oem steering rack then you have to keep them. A lot of people swap it out for the e36 m3 steering rack or IIRC a z3 steering rack. It's a nice and easy upgrade and decently cheap if you can find one at the junk yards. And you can get the necessary spacers for the steering rack swap on e30tech.

edit: didnt see that it was an m3 rack w/hardware

[Den_k321]

Does anyone know if i have to remove those bigger aluminum tubes in front of the steering rack?

[ck_taft325is]

Wow, clean bay! Was that just pressure washing?!

[AbeSonic]

cleaned my bay a bit

Good progress man! Super clean engine bay now!

[Den_k321]

you forgot to cover the hole where the ecu wiring went in, hopefully you didnt soak your glove box from pressure washing.

i had it covered, took it off already... but i didnt cover the hole for tranny/shifter... lol

[AirplaneBuilder]

you forgot to cover the hole where the ecu wiring went in, hopefully you didnt soak your glove box from pressure washing.

[Den_k321]

cleaned my bay a bit