Anyone local have a Torque wrench capable of 300+ lbs?

[Cadame30]

I would like to borrow it, and can compensate you for your time...

[Wschnitz]

300+lbs... Wtf? No i don't or id gladly let you use it.

[Cadame30]

300ft lbs = crank bolt torque

[bmwm42]

300ft lbs = crank bolt torque

What engine bud

[Andrew325is]

Is that what TIS specifies? Usually you torque it to a certain value and then to a certain angle twice? Its a PITA if there are 4 like on the S54. I have a torque angle meter... Also, as I'm sure you are aware, use a new bolt and use a good snap-on socket so it doesn't strip. ;)

[Cadame30]

What engine bud

S50 crank bolt

Is that what DIS specifies? Usually you torque it to a certain value and then to a certain angle twice? Its a PITA if there are 4 like on the S54. I have a torque angle meter... Also, as I'm sure you are aware, use a new bolt and use good snap-on sockets so it doesn't strip. ;)

Yea, I have a new bolt ordered. there not to bad really 10$ or so

DIS specifies 300ft lb +/- 15lbs

[bmwm42]

S50 crank bolt



Yea, I have a new bolt ordered. there not to bad really 10$ or so

DIS specifies 300ft lb +/- 15lbs

i could probably help you crack it loose

[Andrew325is]

Here's one at Harbor Freight tools that goes to 300 ft-lbs. http://www.harborfreight.com/3-4-qua...rench-808.html

[Andrew325is]

This one's a little cheaper on ebay http://www.ebay.com/itm/Professional...item3f0623cb85

[Ryann]

Put some blue Loctite on it and bang it on with a decent 1/2" drive gun. Done.

[Cadame30]

i could probably help you crack it loose

Im installing it...:o



Ill check out harbor freight