FS: 5-lug, manual swap, NIP

[Mafiaracers]

FOR SALE: the better part of a 5-lug and manual swap.

Was acquiring parts for some time now to do a manual swap and 5-lug conversion on my late model coupe. I have since decided on a new direction and am yarding off my parts. Prices are OBO. Open to offers so long as they are reasonable. Local preferred, will meet if reasonable distance. Will ship big stuff if we can agree on price for that service.

Thanks for looking
call, text, PM, email
Chris 503-490-4248

Parts:
318ti trailing arms and hubs SOLD
getrag 260 transmission $150
late model drive shaft for coupe SOLD
Trans mount bracket SOLD
95M3 control arms (does not have new ball joints yet) $100
95M3 calipers, pins, brackets front and rear (need rebuild) $100
Single mass m20 flywheel (needs surface), sach plate and disc in excellent condition SOLD
Z3 steering rack (reman) with NIB tie rods and PS delete plate SOLD
Bimmerworld v2 braided clutch line SOLD
UUC trans mounts SOLD
UUC clutch stop SOLD
Jaffster shift knob $80
Ireland brass pivot pin SOLD
late model pedal assembly SOLD
NIB: $make offer
clutch master and slave cylinder SOLD
rear main and housing sealSOLD
shift boot SOLD
guibo SOLD
pilot bearing SOLD
trans front and rear seals SOLD
center support bearing SOLD
throwout bearing SOLD
front window gasket and lock strip IN BLACK $100

[kronus]

oh excellent, I need a bunch of this. sending PM.

[Mafiaracers]

updated

[mattewhite30]

pm sent.

[EN318isPDX]

pm sent

[Mafiaracers]

responded

[ser1992]

have you ever driven the car the tranny came out of of know its mechanical condition? mine has developed a grind, if i swapped one in that was also busted... >:(

[Mafiaracers]

I purchased the transmission from an older gentleman who had plans of m20+ 5-spd swapping his e21. It sat in his garage for about 2 years before his plans fizzled out and I acquired the transmission from him sometime last year. So it has been sitting for 3+ years as a paperweight. From what I understood in my conversation when I purchased it, it came from a perfectly good running 325i chassis who's owner had removed it for an m50 swap. Supposed to have around 150k on it.

Far as I can tell, it spins very freely, spins silent. I attached a shift linkage to it and bench-tested the lever...hits all gears no problem.

I hope that answers your question.

[EN318isPDX]

Rear trailing arms/hubs are sold! Thanks Chris

[Mafiaracers]

trailing arms sold. Thank you!

[e30austin]

Rear trailing arms/hubs are sold! Thanks Chris

And so it begins...

[EN318isPDX]

And so it begins...

Yep! Fuck geometry

[tytypetersen]

Need a M20b25 flywheel for my 89. i Single Mass.
Does it have > 32mm so I can resurface? Good teeth? Would you sell separate from the clutch and pplate?

Shipped to 98075?

Thanks