Alright, So I have been working on shaving and stripping my bay before I put my s52 in.
I have a few questions for the gentleman that have accomplished this project already, and can throw some general knowledge my way.
Progress so far and tools I have.
I would say progress is @ around 92.5% and mostly down to bare metal.
I am running into trouble stripping the paint behind the strut housings,
The battery tray, little nooks and crannies between the radiator support,
and last but not least:dot:
The lower parts of the engine bay on the left and right side with the holes in it under the brake booster.
I dont know what its called.
But FUCK THAT PART OF THE ENGINE BAY
TOOLS I HAVE:
Dremel with many attachments.
DeWalt Angle grinder with 2 different wire wheels.
Assorted Wire Brushes.
and I have used a spray can of Paint eater stuff, that surprisingly worked very well.
I Would like some input on what you guys have Done/TroubleShot During this project.
Also Any Suggestions are welcome bitches!
I have a few questions for the gentleman that have accomplished this project already, and can throw some general knowledge my way.
Progress so far and tools I have.
I would say progress is @ around 92.5% and mostly down to bare metal.
I am running into trouble stripping the paint behind the strut housings,
The battery tray, little nooks and crannies between the radiator support,
and last but not least:dot:
The lower parts of the engine bay on the left and right side with the holes in it under the brake booster.
I dont know what its called. But FUCK THAT PART OF THE ENGINE BAYTOOLS I HAVE:
Dremel with many attachments.
DeWalt Angle grinder with 2 different wire wheels.
Assorted Wire Brushes.
and I have used a spray can of Paint eater stuff, that surprisingly worked very well.
I Would like some input on what you guys have Done/TroubleShot During this project.
Also Any Suggestions are welcome bitches!
Comment