I have a setup where I'm able to get CAN signal from a driveshaft to read the torque (full bridge strain gauges that are transmitting the torsion on the shaft wirelessly to the remote receiver). The Receiver provides the signal over CAN, + and -.
Not familiar with MS2/ tuner studio.... will CAN inputs on MS be able to log the data and plot TQ/HP in Tunerstudio? Would be cool to have a real life dyno logging setup
Not familiar with MS2/ tuner studio.... will CAN inputs on MS be able to log the data and plot TQ/HP in Tunerstudio? Would be cool to have a real life dyno logging setup
Comment