Trying to replace the input shaft seal on the Getrag 260.
Got the housing off. Seal came out with some difficulty.
Lubed the new seal and tried to hammer it in with a large socket.
Managed to bend and tear the seal...
I ordered another couple from FCP.
Is there a trick to installing these? Does the hammer and socket method not work? Do I need a press?
Got the housing off. Seal came out with some difficulty.
Lubed the new seal and tried to hammer it in with a large socket.
Managed to bend and tear the seal...
I ordered another couple from FCP.
Is there a trick to installing these? Does the hammer and socket method not work? Do I need a press?
Comment