I assume there is enough drain from the back to the front like the stock ones are?
Announcement
Collapse
No announcement yet.
formyhealth - 1991 318is Build Thread - now with 1000% more 1JZ-GTE
Collapse
X
-
Originally posted by econti View PostI assume there is enough drain from the back to the front like the stock ones are?
I'll be baffling the sump area and may end up inserting a slanted plate inside of the flat section to give it the proper drain angle. Or I give the whole engine 1 or 2 degrees of forward slant which should do the same thing.
Comment
-
Diy big brake solution arrived! These are 4 pot calipers from a 1991 rx7.
Sent from my SM-N950U using TapatalkLast edited by formyhealth; 03-21-2019, 07:24 PM.
Comment
-
Well, I scored one hell of a deal today. 15x7 Team Dynamics wheels with healthy looking Toyo Proxes RR slicks, $300!! Quite happy and they fit over the rx7 brake calipers.
Sent from my SM-N950U using TapatalkLast edited by formyhealth; 05-30-2019, 06:50 PM.
Comment
-
Originally posted by formyhealth View PostOooooh [emoji3]
Sent from my SM-G973U1 using Tapatalk
Sent from my SM-G960U using Tapatalk
Comment
-
Originally posted by Sh3rpak!ng View PostWhat's that?
Sent from my SM-G960U using Tapatalk
Comment
-
Originally posted by formyhealth View PostThat's a wireless (infrared) button pad that sends a signal to a programmable relay controller. It mounts behind the steering wheel and I'll be using it for turn signals, wipers, launch control ;) etc.
Comment
Comment