Looking in the bently it says fuel pressure for an m20b25 should be 43.5psi +- 0.9 psi.
I am getting a steady 36 psi.
That's the rating for the eta engines... Is this something to be concerned about? Already tested my FPR and confirmed that is not leaking or stuck open/closed.
When I remove vacuum from the FPR (causing it to close) I end up getting around 46 psi which is right on par with the spec for that test.
Is this lower than usual fuel pressure something to be concerned with?
I am getting a steady 36 psi.
That's the rating for the eta engines... Is this something to be concerned about? Already tested my FPR and confirmed that is not leaking or stuck open/closed.
When I remove vacuum from the FPR (causing it to close) I end up getting around 46 psi which is right on par with the spec for that test.
Is this lower than usual fuel pressure something to be concerned with?
Comment