S50 crank, m20 stroker questions

[Dagamus(NM)]

I have them.

Old thread bump, but might you happen to still have these? How about the bolt/washer thing?

[SkiFree]

I posted that when I was still at IE. IE will still have them.

(you have to call, they just don't want to sell to someone who isn't comfortable using heat. The ring is heated pretty dang hot, and if someone isn't careful/experienced they can get it caught cock-eyed when sliding it on).


As a second option, John at WOT-Tech may still have some of the batch he did.

[Dagamus(NM)]

I posted that when I was still at IE. IE will still have them.

(you have to call, they just don't want to sell to someone who isn't comfortable using heat. The ring is heated pretty dang hot, and if someone isn't careful/experienced they can get it caught cock-eyed when sliding it on).


As a second option, John at WOT-Tech may still have some of the batch he did.

Thanks. I will contact John. I cannot support IE. Well, I cannot support Jeff. Fuck that turd.

[ForcedFirebird]

The ones I make only need ~250° to slide on. Toaster oven works great hehe.

[Dagamus(NM)]

The ones I make only need ~250° to slide on. Toaster oven works great hehe.

I just emailed you John. How long at 250?

[ForcedFirebird]

Until it's heated through. Doesn't hurt to go a little higher, it gives more time to slide it on. The crank cools it pretty quickly, so make sure you have it on straight.

[Dagamus(NM)]

Until it's heated through. Doesn't hurt to go a little higher, it gives more time to slide it on. The crank cools it pretty quickly, so make sure you have it on straight.

Cool. I will pass a torch over it if I get it crooked.

Thank you both for helping. Glad to not have to support IE or get fleeced by MM.

[SkiFree]

Haha, ok cool. Glad you got it worked out.