I'm running the standard whodwho MS ECU, and I want to add electronic boost control. I have no idea how. Halp?
Announcement
Collapse
No announcement yet.
How to add EBC to whodwho MS ECU?
Collapse
X
-
-
Originally posted by ThatOneEuroE30 View PostI believe you need this and the solenoid unless it has the electronic boost controller in it then you just need the solenoid.
https://www.diyautotune.com/product/...ntrol-mod-kit/
Is whodwho's megasquirts based off microsquirt? If so, you only need the solenoid.
I would email keith if I were you to double check.1987 325is 2.8L Stroker Turbo "Little Pickle aka The Green Turbo Sled"
Comment
-
Can that connector above be used for a knock sensor?318iS Track Rat :nice: www.drive4corners.com
'86 325iX 3.1 Stroker Turbo '86 S38B36 325
No one makes this car anymore. The government won't allow them, normal people won't buy them. So it's up to us: the freaks, the weirdos, the informed. To buy them, to appreciate them, and most importantly, to drive them.
Comment
-
Originally posted by downforce22 View PostCan that connector above be used for a knock sensor?
When you pin whatever you're pinning to the labeled connector I posted, you go into Tuner Studio and enable that parameter according to the pin - so doing that for a knock sensor should be possible too I believe.
I think when I enabled EBC and/or LC in Tuner Studio, it was labeled something different in the drop down menu - definitely not "EBC" or "LC".
Also, for those that are trying to implement launch control with Keith's megasquirt, the PNPDIY instructions found on the site won't work. You have to pin your momentary switch to a 12v power rather than ground like the way it's documented online everywhere.
Comment
Comment