Announcement

Collapse
No announcement yet.

FS: 1987 325i 2.7 Stroker - Georgia

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    FS: 1987 325i 2.7 Stroker - Georgia

    Thinking about putting the E30 on the market. Here's the overview:

    It is a 1987 325i four door with a sort of cheap Imolarot paint job that shines up nice. Sits on 14 inch weaves with Falken tires with good life left Here's a rough list of mods to the car:

    2.7i Stroker conversion - PO said the entire bottom end was rebuilt, and the top end was recently rebuilt at Markert Motorworks
    Bilstein Sport Shocks
    Ireland Engineering Stage 3 Race Springs
    Turner Motorsports 91 Octane chip
    Treehouse Racing Eyeball Arm CABs
    Ireland Engineering poly subframe mounts
    AKG Trailing Arm Bushings

    Interior:
    Nice set of leather comfort seats in the front
    ZHP shift knob
    Custom gauge cluster
    Working odometer!

    Here's a list of some recent maintenance:
    Left front wheel bearing (Harrison Motorsports)
    Crank position sensor (Harrison Motorsports)
    Rear suspension overhaul (Markert Motorworks)
    Top end rebuild (Markert Motorworks)

    What's wrong:
    Brake master cylinder is leaking
    Needs a driveshaft center support bearing
    Oil leak, not sure what from
    Small cosmetics, like dings in the paint and a cracked dash

    This is a solid, good looking E30 that only needs a little bit to be a great DD or track car. It handles great with the suspension mods and pulls hard with the chip and the stroker. It even has a 2.93 LSD so it gets low 30's mpg highway. The paint looks great from a few feet away and it turns heads everywhere.













    Looking for $3500 or best offer

    I'm located in Middle Georgia

    #2
    Lol @ your confused, shirtless neighbor in the first pic.
    1990 Brilliantrot 325iS Build Thread
    1989 Zinnoberrot M3 Build Thread

    Comment


      #3
      Originally posted by AWDBOB View Post
      Lol @ your confused, shirtless neighbor in the first pic.
      Lol, everyone keeps commenting on that. I should probably crop the poor guy out

      Comment


        #4
        ttt

        Comment


          #5
          Would this need to be trailered back up to NJ? Or could it make the drive?
          I like cats.

          Comment


            #6
            It could make it. I'd be most concerned about the driveshaft. But the fluid leaks are slow enough that they wouldn't be an issue. If you did drive I'd have someone with you in case of a breakdown

            Sent from my Nexus 4 using Tapatalk

            Comment


              #7
              Bump

              Comment


                #8
                Are you interested in trades at all?

                Comment


                  #9
                  Nope sorry I need cash

                  Comment


                    #10
                    Bump. Make me an offer!

                    Comment


                      #11
                      I'd buy if it were closer. I don't want to drive it back with leaky brakes though. How badly does it need a shaft bearing?

                      Comment


                        #12
                        There are some pretty harsh vibrations if you accelerate hard. But if you drive normally it's not too bad. Brake leak is pretty slow

                        Sent from my Nexus 4 using Tapatalk

                        Comment


                          #13
                          Make me an offer!

                          Comment


                            #14
                            Up

                            Comment


                              #15
                              Would you pay for a ppi from Harrison?

                              Comment

                              Working...
                              X