FS: M20 Performance Camshafts from BimmerHeads

[MR 325]

These are reground from OEM BMW M20B25 core cams. These cams are a great upgrade for the M20 engine; they make an improvement you can really feel. Design and results are very similar to a Schrick cam but for a fraction of the cost. Higher lift helps mid-range power and extra duration helps the top end. These cams will pull right up to 7000 rpm with ease. Works well with upgrades like chips, free flow air filters, headers etc. We have 3 different grinds available! See the drop down menu on our website to make your selection.

------------------------------------------------------------------------------------------------------------------------------------------------------
TO PLACE AN ORDER PLEASE VISIT OUR WEBSITE:
www.BimmerHeads.com
------------------------------------------------------------------------------------------------------------------------------------------------------

If you have ANY questions please do not hesitate to ask!
You can PM me directly or email to info@BimmerHeads.com

We can also regrind S50/S52 cams. PM or email for details!

Visit BimmerHeads on Facebook!

[Ceeker]

Hey, what set up is required to run this cam? thx.

[RobertK]

Hey, what set up is required to run this cam? thx.

A M20 cylinder head.

[Mr. Tasty]

A M20 cylinder head.

made me laugh

[MR 325]

This will absolutely work in a head that's otherwise stock.

This is also the same cam we run in most of the heads we sell.

I've got it in two of my own vehicles and friggin love it!

[WhyNot]

Got a link that describes the improvements?
On stock head?
On upgraded head?

[MR 325]

This regrind is a great upgrade for the M20 engine. It makes an improvement you can really feel. Design and results are very similar to a Schrick camshaft (but for a lot less money). Higher lift helps mid-range power and extra duration helps at the top end. This cam will pull right up to 7000rpm. Works well with a stock engine or with upgrades like chips, free flow air filters, headers, MAF conversion, exhaust etc.

Hope that helps! :)

[OldSkoolE3]

Videos of idle and pull?

[MR 325]

Best I have to offer. Both cars have this 274 camshaft.

[E30_fiend]

For anyone who's wondering what 415 lift means, it means there's .415" of lift on the cam which comes out to 10.541mm of lift at the valve.

For comparison, a high lift Schrick camshaft has 11.4mm of lift. Which is a TON of lift.

This means that this cam is a GREAT choice over a Schrick for the price its being offered.

BUY THIS GUYS CAM!!!

[trippmann]

i was about to ask if you needed to find the other cam to make it a pair... then i remembered that m20's are sohc's haha. free bump. interested but not till the spring/summer months.

[downforce22]

do you need larger eccentrics?

[flyboyx]

sounds like a fantastic deal. can you do a similar regrind with m50/2 cams? i would want a set if you can.

[MR 325]

do you need larger eccentrics?

We've installed over 30 of these cams and haven't needed them yet. It is possible that they'd be necessary but it's highly unlikely.

sounds like a fantastic deal. can you do a similar regrind with m50/2 cams? i would want a set if you can.

We've done a few sets of those too! We would need your cores before hand though. PM for pricing.

[MR 325]

PM's replied, thanks.