FS: Many M/S50 engine parts AND complete 318is drivetrain

[Brew]

would you sell the S50 rods seperately?

As of right now, I'm holding onto all the bottom end parts for FredK. If he doesn't pick them up on Sunday, they'll be up for grabs. There has been quite a bit of interest in them separately, so they'll go to the best offer.

[FredK]

Nando, I should have an extra set of S50 rods if I pick this bottom end up from Brew. I am definitely gonna go over to his house on Sunday to check it out, if everything is cool I'm going to buy it. I'll PM you sometime after that to let you know if my S50 rods are available.

[nando]

that's cool with me.

[Pedro]

how much for just the s50 pistons?

[Brew]

how much for just the s50 pistons?

As of right now, I'm holding onto all the bottom end parts for FredK. If he doesn't pick them up on Sunday, they'll be up for grabs.

If I did sell them separately, probably $50/piston.

[Brew]

BUMP!

S50 Bottom-end parts sold, along with the M50 intake manifold.

[netcsk]

will the head bolt up to a 96 328i? I believe it's M52 correct? Single Vanos but OBDII. Anyone know?

[Brew]

Sorry, missed that post.

The S50 head is the same casting as the M52 heads AFAIK, so yes, it will bolt up. You would be better off swapping the S50 internals over to your current head casting (assuming its in good condition) because the head I'm selling needs some machining. But everything would swap right over.


Oh, and BUMP! Cams sold and 21.5# injectors added.

[Brew]

bump? :)