If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
2. This will be bolted to an m50 so I am not positive on fitment.
3. This is a budget situation. Im trying to do this with as little as possible. just a resurfaced flywheel and a new clutch disc, tob and p.p.
m50, m20 and even m42 all "bolt up". Your starter will have to match, as all baby 6's and 4cyl use the same bell housing bolt pattern, but have different tooth count.
Bump, so considering I need to match the flywheel to the starter; I'd prefer to find a used m50 wheel or at least a single mass m20 wheel. Anyone have one laying around
Comment