JOM Coilover Group Buy

**mightywhitey** · 01-08-2011, 10:49 AM

mine actually came today too

**jintermont** · 01-08-2011, 07:53 PM

Still waitin on the front adjuster :-(

**ck_taft325is** · 01-08-2011, 09:01 PM

Originally posted by nickpro

Anyone using these on track?

It's a $380.00 coilover kit.

No. It's a street kit and a damn good one but again, no, I would not use this on the track.

**Zinno_e30** · 01-10-2011, 09:10 AM

Just got mine today. That was extremely quick.

**E30AWDAZ** · 01-10-2011, 09:45 PM

Put them in today, I need to take pics in daylight so I'll post em up tomorrow.

**mightywhitey** · 01-10-2011, 09:47 PM

what did you think are they low enough for you?

**E30AWDAZ** · 01-10-2011, 11:12 PM

Yeah it's pretty low. I didn't even have to cut the perches

**Zinno_e30** · 01-11-2011, 09:45 AM

Any more pictures?

**mightywhitey** · 01-11-2011, 10:00 AM

**einstein57** · 01-11-2011, 11:08 AM

I've been too busy to finish the passanger side. Will take some pics of it on the ground by next week.

**E30AWDAZ** · 01-11-2011, 11:15 AM

Uploading to my computer a flood of pictures stay tuned...

**E30AWDAZ** · 01-11-2011, 11:30 AM

380 shipped!!

BEFORE:

Ready to get low...

After Installed on the lowest setting no spring pads:

I'm happy with the results;)

**mightywhitey** · 01-11-2011, 11:37 AM

For not cutting the strut tubes at all I am impressed with that for sure. Now I want to see some cut tube and GC rear spring dumpage. Good pics, thanks.

**E30AWDAZ** · 01-11-2011, 11:46 AM

Originally posted by mightywhitey

For not cutting the strut tubes at all I am impressed with that for sure. Now I want to see some cut tube and GC rear spring dumpage. Good pics, thanks.

Thanks keep in mind they still aren't settled yet. I would give these coilovers a 8 out of 10 because they are perfect for street setups! The shocks are a tad too soft for any other application though. It still rides alot smoother than my stock springs and blown shocks for sure. Now Im just waiting on my wheels to come in the mail

**bronman69** · 01-11-2011, 12:19 PM

just wonderin... on the front strut install. the stock ones sit in the tube filled with oil, and to take them out you have to unscrew it to pull the strut out. but in the pictures his front strut adjuster is sitting on the perch. as my adjuster screws into the strut housing. where the oil is put in to transfer heat front the strut to the housing.its very difficult to adjust.

did i just do it wrong?

JOM Coilover Group Buy

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment