German Engineering Coilovers

[HennaE30]

One more run, lets do this!! I would be in for a set. Does JOM still make E30 coilovers? Looking for something cheap around this ~$400 price range.

Yes JOMs are crap though.. But if your looking to get low for cheap thwn go for it. There was some for sale in the classifieds for $275 iirc

[E30swift]

One more run, lets do this!! I would be in for a set. Does JOM still make E30 coilovers? Looking for something cheap around this ~$400 price range.

[318kid]

I am trying to order a set of these but the link does not bring it up to order the coilover set , is there somewhere else I can order these?

He doesn't have these kits made anymore. They were all sold out a year ago. The last few pages have been people trying to get him to make one more run.

[TS87325IS]

I am trying to order a set of these but the link does not bring it up to order the coilover set , is there somewhere else I can order these?

[HennaE30]

what is the preferred or best Strut to use with these? Konis? and can they be ordered with custom spring rates?

read?

[jksmith]

what is the preferred or best Strut to use with these? Konis? and can they be ordered with custom spring rates?

[Jib05]

in for rear springs and adjusters. :)

[Harry's E30]

hey tried PMing but your inbox was full do you have any extra top hat spacers?

[325_e30]

Had these and loved em. Only took them off to get a bag setup. They'll go on my next e30 too.

[HennaE30]

I would be willing to do this as soon as you are up for it.

[jwal]

I would be willing to do this as soon as you are up for it. I would also be interested in a setup for my e36...if you feel like developing something ;)

[einstein57]

Assuming i had the $12k required to start placing orders on springs, adjusters, material, packing, etc, it would still take 4-6 months for them to get made.

[jwal]

How would that ride? I'm looking into these for my daily beater 318is.

[Northern]

That would be sweet. Could we try to match some spring rates for the valving?

Everything I've read about Koni SAs and their iX counterparts say they adjust stiff enough for 450/650, and anything over that you should consider getting them revalved.

[jwal]

That would be sweet. Could we try to match some spring rates for the valving?