24v harness adapters

[nando]

I'm in.

put yourself on the list :)

might have a few C104 plugs for those with early cars.

[M-technik-3]

I'm going to go ahead and post this up and see how far it goes. :)

This is a group buy for 24v swap adapters. I'd like to get 10 before I order any supplies. I already have pins, wires, etc.

Basic adapter (just C101 to X20): $175 (shipping included)
add oil level sensor: $25
add C104 for early cars: $25 (assuming I can find connectors)
OBDII - pigtail for X6031 (CEL pin only) - no charge

Round C101 cars only please (this may change in the future, but finding square C101 connectors is difficult)
OBD1 harnesses preferred.

Early cars with a C104, and oil level sensor wiring would be extra (more parts, more work, more R&D). As an alternative, I can supply a labeled pigtail at no extra charge. If you have a 318is you don't need the oil level sensor.

Approximately 6" long. Military grade wires, made in Japan.

Add yourself to this list in this format:

#. Name
E30 Model & Build Date
Harness approx. build date
C104, OBDII, or Oil level sensor needed, or pigtail

1. M-technik-3 3/86 325e have some C104's as mentioned. OBDI and oil level Sensor.

2.

3.

4.

5.

6.

7.

8.

9.

10.

I'll start collecting payments when we get close to 10 people.

[golde30]

ahhhhh r3v, lots of talk until its time to shut up and hand over $$$, then crickets. this is a good deal guys, new wires, new pins, no research required, buy now and save for future swap plans.

[Nick_S]

I'm in.

[nando]

been trying to find a connector for that (it's a 3 pin), no luck yet. maybe it'll have to be a pigtail and a couple pins that you can crimp.

[M-technik-3]

I've been lazy lately But need a C104

[nando]

sure. for now though, I want to stick to round C101s.

still getting PMs, but nobody on the list. lol.

[einstein57]

Seems to be nothing but etas at my local yard. Let me know if you need some square plugs.

[nando]

I posted the link in my feeler thread too. haha

[JCarp90]

Sometimes I forget this section exists.

Crosspost boss. Nobody will tell you that you can't. ;)

[nando]

where's all the people who were PMing me for the last few weeks? :)

[MR 325]

Great deal for quality work.

[nando]

Now open for general purchase. these are built to order. I have parts in stock to build 4 more at this time. I can handle making about two a week at the most.

OBD1 adapter: $200
OBD2 adapter (with pigtail for X6031): $225

early cars (C104) add $25. Must ship me a C104 to splice on.

I cannot do Square C101s at this time unless you have one to send me.

Here's two examples of my adapters:



All new wires, pins, connectors, & boots:


professionally crimped:


Approximately 6" long. Military grade wires, made in Japan.

Turnaround time is approximately 1 week for OBD1 and 2 weeks for OBD2. OBD2 is more complicated and takes more time, and I only make these on Saturdays.