If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
My laptop took a dump last week, so I've been holding off on replying to a few people rather than reply from my phone... I am hoping to have it back today or tomorrow, so I will get back to you then.
You can use a 506 chip with a silver label ECU and a clipped wire and it will work splendidly. You cannot use a 413 (non-ews delete) chip with a 413 red label though as it will still throw an EWS code.
Personally i would rather start with a non EWS platform as it leaves more options in chips and more then likley cheaper in the long run. Plus its just removing one more variable of problems that could happen.
Actually, TRM is showing the EWS delete chip for $204.95.
I was recently thinking about the 413 red or silver label discussion. I had kept thinking that I really just needed to concentrate on finding a red label 413 for my future S52 with OBD1 swap...but then I came to the realization that the factory chip in a 413 isn't going to have the correct tune for my application, as it would be suited for an M50.
You are going to pay around $250 for an S52/OBD1 chip in most cases. The silver label 413's seem to sell for half of what red labels do (just from my recent searching) because they have EWS enabled. Seeing as that $250 will get you the proper S52/OBD1 chip with EWS deleted, it makes sense to just go ahead and save money on the silver label 413 DME.
Am I correct on this, or is my lack of sleep taking over? Of course this would only apply to S50/S52 motors-not the M50.
Leave a comment: