Where does this hookup to?

[kermugit]

So, I have looked up some info on this issue and the plug Im holding is not for the vent canister, nor for the tps or reverse lights. WTF is it for? need help

[kermugit]

What? I have the c101 pig tailed and hooked up? Im holding a two prong plug. Need clearing up.

[accident]

cam sensor?

[herlsy]

which m5x version?

Off the top of my head...2 prong:

Fuel Evap
Air Intake Temp
Oil Pressure
Coolant Gauge
Engine Temp (coolant, usually a Blue connector)

[kermugit]

Yeah sorry, 06/95 M50tu. I know its not the fuel evap, air intake temp(check trice), negative on oil psi, engine temp. But, coolant temp gauge? I have that pluged in on the head next to the black dme temp sensor. Im stump? I have checked and checked. Cam sensor, huuum.

[boyd_dave]

what color are the wires?

[herlsy]

I was just naming 2 pin connectors on the harness that i know of. Best way is to pull back the boot, note the wire colors and look at the ETM for your harness.

[Matt-B]

oil level in pan

[samiam3356]

3 Prong Connectors
Knock Sensors
Cam Sensor
Crank Sensor
TPS
Oil Level Sensor
ICV
2Prong
Air Intake Temp
Valve for Charcoal Cannister
Temp Sensor for DME
Temp Sensor for Cluster

[phreshkid]

3 Prong Connectors
Knock Sensors
Cam Sensor
Crank Sensor
TPS
Oil Level Sensor
ICV
2Prong
Air Intake Temp
Valve for Charcoal Cannister
Temp Sensor for DME
Temp Sensor for Cluster

Temp sensor for cluster should be one prong, no? It only "sends" temperature o
Info to the cluster.

Edit: nevermind, you were talking about the female plugs that connect into the sensors.

[samiam3356]

Same for the Oil pressure switch and Vanos Solenoid (I Believe)

[kermugit]

okay, I was thinking and I have checked this morning and it is not oil psi, nor vanos plug, could it be air temp, but I checked that plug under the manifold. The wires from that plug is red with white stripe and brown wire. I checked ETM but no color coding.

[kermugit]

The plug is on the loom that houses the connector that attaches to the air flow meter if that helps. Thanks everyone for replying.

[samiam3356]

Judging by how far you can pull it out from under the intake it has to be air temp, Char Cannister, Vanos

It is a 2 prong connector right?


EDIT It IS the charcoal cannister then.^^Based off your second post before I could respond

[herlsy]

If its on the part of the harness that splices off from the Air Flow Meter, its the charcoal canister evap valve, at least it's that way on my NV harness.