Announcement

Collapse
No announcement yet.

Looking to have your 24V headers coated?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Looking to have your 24V headers coated?

    I'm going through JetHot to have my Supersprint reps ceramic coated, and in doing a little research, I found that VAC Motorsports actually offers the service through their site for $219!



    It's not just for 24V motors obviously, but since most people do run an aftermarket header with their swap, I thought people would like to know about this. Much cheaper than I was anticipating, and JetHot coatings are an inside/outside coating, whereas most places just do external.
    Last edited by Jand3rson; 01-15-2012, 10:06 PM.

    #2
    there's a place in the PNW that does it too. have yours been run? it costs extra if they're used because they have to clean them. Mine were inside/out.

    it also makes an unbelievable difference in underhood temps.. for $200 or whatever it's totally worth it.
    Build thread

    Bimmerlabs

    Comment


      #3
      cool. i might have to do this when I get to that point on my build. $219 isn't bad at all.
      '84 325e - "Elizabeth"
      '87 325e (SHELL) - "Sleeping Beauty" - COMPLETE PROJECT PART-OUT - S54, 5-LUG, and MORE

      sigpic

      Comment


        #4
        Originally posted by nando View Post
        there's a place in the PNW that does it too. have yours been run? it costs extra if they're used because they have to clean them. Mine were inside/out.

        it also makes an unbelievable difference in underhood temps.. for $200 or whatever it's totally worth it.
        Yeah, they have, and they have the shitty flaking header paint on them, too. I just got a quote back from them and they said $250, probably going to do it in a few weeks. I was told by them and a few others that it will also cut down the rasp a lot, because the steel on the Supersprint reps is so thin.

        Comment


          #5

          Superior coating at very reasonable prices. I would pick swaintech over jethot any day.

          Comment


            #6
            I'm actually going to have it done at a place here in town now. They do the same thing, and I won't have to pay probably close to $100 in shipping round-trip.

            Comment


              #7
              I'll throw this out there as well because they do great coating that really helps with temps. They do pistons and such as well.
              Introducing VADER v3.0 THE ART OF EXCELLENCE Buy No Serrations We didn't buy into the "serrated circle edge" concept of locating the cap. Using hardened steel dowel pins is the only way to fully achieve strict cap alignment and maintain bore concentricity under brutal conditions...all the time and every time. F1 Beams A completely redesigned

              Comment

              Working...
              X