Oil Light Reset

[Robert]

How do you guys normally reset your oil light?

I tried an e30 tool , doesn't work.

[IRON-E]

How do you guys normally reset your oil light?

I tried an e30 tool , doesn't work.

Which tool did you use?

[Robert]

one that worked on my e30 .

[Robert]

i think it's different for the m50 wireharness. don't want to fry anything.

[rlddlr53]

is your diagnostic port functioning?

[328ijunkie]

Should be the same assuming your diag port is wired.

[e30s50dan]

Short out those two pins! Can't remember

[Robert]

not sure, how do i know if it works lolz

[DesertBMW]

How do you guys normally reset your oil light?

I tried an e30 tool , doesn't work.

I had this problem, the green lights would not clear grounding pin 7. Then I just changed odometer gears on my cluster and I inspected the board and two batteries. The batteries are good, but then I noticed the damage on the board because I used longer screws on the bottom center trim part, the longer screws went trough the cluster digging and damaging the board, this may be the common issue.

[MR 325]

If it's not working you have a wiring issue, it should work no differently than when you had the M20.

[nando]

yeah, somebody didn't hook up the wiring properly.

[Robert]

typical, it's one of those wireharness adapter that were sold on here.

[ZM Blue Devil]

Should be the same assuming your diag port is wired.

this

[mammoth_e30]

typical, it's one of those wireharness adapter that were sold on here.

bam. tear it all apart and start over.

[nando]

typical, it's one of those wireharness adapter that were sold on here.

rymes with megschmoe?