So if i got the harness with the motor, what work do I need to have done to it for an OBD2 swap? I am just not sure what you had Markert Motorworks do with the harness.
-
-
I am doing a M52TU Dual VANOS swap into my newly acquired 1987 E30..
Need advice on parts (I have been thru the List)
I bought a E39 for a parts car not sure if I can use everything...
But it came with a ZF box!!!Last edited by PG_E30; 05-07-2018, 05:30 AM.Comment
-
what did you end up doing for the oil temp and pressure sensors? I only have one sensor (pressure i believe) on filter housing on my S52, trying to figure out what the best option is to get temp sensor (and what part # for sensor). Looking at Rally Road block
Comment
-
I used that block off from a different manufacture and it works well.
Sent from my iPhone using TapatalkComment
-
know this is old but ill be swapping m50 to s52 to this is good info to haveComment
Comment