If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Would I need the tilted trans mount if I use the Getrag from e34? And can I use the stock driveshaft since its the same as e30? Or does the e34 have different mounting points or larger outputshaft?
The getrag from an e34 has a larger output flange. IIRC you'll have to use a 325e, 328i, or e30 m3 driveshaft because they have the larger matching flange.
The getrag from an e34 has a larger output flange. IIRC you'll have to use a 325e, 328i, or e30 m3 driveshaft because they have the larger matching flange.
Alright thanks. And mounting I can use stock mount?
Assuming we're talking about the Getrag from a M50 E34 you can use the stock E30 trans brace.
Correct. I have a motor/trans from a 95 e34 touring. I also just planned on swapping transmission flanges so I can run the stock e30 driveshaft. Thanks for the help!
Comment