if you ever decide to make any more of these i will be in for one. im currently pulling the drivetrain from a manual ix to swap into my auto ix. hopefully youll be able to make some eventually i will definitely buy one.
New set has arrived! Front shaft uppgrade *Finland-Fix*
Collapse
X
-
Just wonder how much this would cost, if some machine shop would make them??Comment
-
My dad would take oneMy Garage
2001 Z3 2.5i Steel Gray/Black (Lexi)
1988 325ix Diamond Schwartz/Black (Izzy)
1989 325i Cirrus Blue/Houndstooth (Stitch)
Feedback
Instagram: Stone.HopkinsComment
-
Looks good. I prefer you should all check your drive shafts are straight, before installing. noticed that mine had little vibration at 60mph, and now when its out, I noticed its not prefectly straight. the pipe has throw of couple millimeters in the middle of it. I dont believe the installing the new head on it reguires balancing since it's perfectly symmetrical, but if it's not pressed straight or welded well, it might bend the pipe littleComment
-
I took my spare transfer case apart to get the sprocket for the machinist.
So I will be producing a new set of these extension by the local machinist. He have done severals machining for me so I can believe these in his hands. Of course I will be doing final inspection on them before sending any :)
Comment
-
I want one. Let me know when, where and how to pay.How to remove, install or convert to pop out windows
http://www.r3vlimited.com/board/showthread.php?t=297611
Could be better, could be worse.Comment
-
-
I wont be accepting any payments before I really have them on me :) Have to be sureComment
-
Comment