Transmission to TC issue

[CrazyPrime]

So I just got my engine in and after I bolted my TC to the transmission I went to put the nuts on the studs that come out of the back of the transmission. When I spin the drive part that connect the output of the transmission to the input of the TC it spins freely with the transmission in neutral. When I tighten the drive nuts to connect the rotating part from the transmission to the TC, it get hard to spin in neutral and it won't go into a gear. So after I tighten 1 of the 3 and try to spin it and tighten the other 2 I can't spin it withheld transmission in neutral.

Sent from my E6653 using Tapatalk

[CrazyPrime]

when I tighten these.

Sent from my E6653 using Tapatalk

[CrazyPrime]

Sent from my E6653 using Tapatalk

[AndrewBird]

Uh... you're missing the flex disk. There is supposed to be a big rubber donut between the flanges. Without it, the bolts would pull the flanges towards each other and put side load on the bearings. Not good.

#1 as seen here:

http://www.realoem.com/bmw/enUS/show...diagId=27_0003

[nando]

yes, you need the flex disk and 3 more bolts.

[CrazyPrime]

Mother Of god I'm a idiot. its been a year since my car was out of commission just slipped my mind. I love rev thanks guys!

[flyboyx]

oy!