Announcement
Collapse
No announcement yet.
325ix front wheel shake, and clunking over bumps
Collapse
X
-
After strut mount and new shocks the clunk seems to be gone. There was a lot of play in the old strut tower bearings, and lots of metal particles in their grease. New ones were needed, those might have been the original. Glad I fixed that.
-
I had a slight clunk and figured out when I initially installed the front struts into the housing, they were ever so threaded loosely. I lifted up the strut accordion boot and took a big monkey wrench to the top of the strut.....and gave it 1-2 turns until tight....and it solved my issue.
Leave a comment:
-
Control arm bushings where just replaced today, made some change but still there is a slight clunk on passenger side, the rods are tight, no play, must be somethijng strut related. There is still no source for inner the rods on ix?
Edit; just check strut nut on top, the thing is just spinning like there is no thread engagement. I have new strut hats, and I can't even replace them because of this. How do you remove them from the strut if it just keeps spinning, I have the special tool and can see that the inner threaded part is not rotating when I turn the nut. I guess this must be the cause of my clunking anyway. What's the best way to remove all of this? I probably need new shocks if it won't spin off.Last edited by rwtags; 09-15-2019, 03:07 PM.
Leave a comment:
-
control arm bushings, ball joints, tie rods, strut mounts..
If you have loose subframe bolts, something is really really wrong. They are huge and really tight.
Leave a comment:
-
325ix front wheel shake, and clunking over bumps
I have a 91 325ix with 219k, i get a weird shaking at exactly 50mph while crusing. I also have a clunking when going straight over bumps from only the passenger side, it seems to not clunk while i am slightly over bumps with the brakes on, but i dont know if that is true or not. Doesnt matter when i turn over bumps or not. I have gotten under the car and replaced the passenger side sway bar mount, and i have new bushings for the sway bar are on the way. What are some things i can check for, i got under the car and was pushing things around but nothing seems to clunk.
I have read that the subframe bolts could be loose, do you think this is a possibility?Tags: None
Leave a comment: