If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
my real question here is how the hell are you guys hitting pan or having to worry about hitting your pan. My subframe and pan is about 2 fingers off the ground and i was just under my car changing my oil and i have only 1 scratch on my pan. I live in Pennsylvania and the roads are as shitty or worse than the roads in most other places. The only real thing to worry about is your exhaust scraping. I scrape exhaust everywhere and have broken off all of the hangers and had to redo them already. granted a skid plate would work on that one odd occasion that you do smack your pan, but i will agree with many of the comments posted above that it would not be 100 percent necessary to buy an expensive pan rather than make one, but not everyone has access to make themselves a pan.
Are you talking about making an entire oil pan? Or a skid plate?
There's a member on here who actually cuts the bottom of a 24v oil pan about 1.5" off and welds on a new bottom. It is no longer the closest thing to the ground.
Comment