ES front to E

[E86_Jando]

Well my e30 is a 86es so which rubber piece will I need to get. Can they be bought new or will I have to search the for sale section

[reelizmpro]

Find someone who will trade u.

[JasonC]

Well my e30 is a 86es so which rubber piece will I need to get. Can they be bought new or will I have to search the for sale section

You'll need one that looks like this one.



Cause if you find one with the brake ducts in it, its the 85 and older that is too short,

[E86_Jando]

Ok thank you all for the help

[mr.vang]

the junk have plenty of them for cheap

[ChefSkinny]

seriously loving that rolling shot. How do I do that to my 86 325e? Are those euro bumpers?

[JasonC]

seriously loving that rolling shot. How do I do that to my 86 325e? Are those euro bumpers?

Thats a stock diving board bumper with the rear bumper trim used to make it have a smooth look.

[ChefSkinny]

ahh ok and it's just tucked. What about the valence / lip thats on it?

[JasonC]

ahh ok and it's just tucked. What about the valence / lip thats on it?

stock 86/87 valance and lip.

[ChefSkinny]

any idea where I can find one of those lips? Never seen one like that.

[jw 325ic]

Just make sure you save your eS front end. One day you'll probably want it back on there.

Look around junkyards and ebay. Theyre fairly popular.

[E86_Jando]

jw 325ic Have you been to any good junk yards around here. I found a few but no much luck with e30s

[Bearmw]

For those who have used the rear bumper strip up front what did you do to replace the turn signals?

[jw 325ic]

jw 325ic Have you been to any good junk yards around here. I found a few but no much luck with e30s

hey i'll pm you a few. there are some good ones around for sure but you have to drive a bit.

[timninja]

Valance is the same....

The early stock front end can look sexy if done right:

wounder if he just uses hand signals?
jk,I want to do this setup just confused on the signals..i guess you could convert your high beams to low beam and run your turns threw it?lol no clue