So ive been seeing a few early models who apply the rubber bumper trim from the rear to the front. This obviously gives it a more simplistic and clean look. The only down side to it is in the process you are deleting the turn signals.
I feel like this look would be cool on a vert, but my issue is i dont want to run into any problems about having no turn signals.
Does anyone have any ideas to get around this or have through of cool places to relocate the turn signals?
I know i saw a R3v post a couple years back who did this and modified his headlights by putting LEDs in his headlight housing and used that as turn signals. Its was pretty sweet. Wish i remember where the post was.
Any suggestions?
Thanks,
Tony
EDIT:
I found the thread!
This is an example of a good turn signal relocation.
There is a quick write up on how to make them on the 2nd page too.
I feel like this look would be cool on a vert, but my issue is i dont want to run into any problems about having no turn signals.
Does anyone have any ideas to get around this or have through of cool places to relocate the turn signals?
I know i saw a R3v post a couple years back who did this and modified his headlights by putting LEDs in his headlight housing and used that as turn signals. Its was pretty sweet. Wish i remember where the post was.
Any suggestions?
Thanks,
Tony
EDIT:
I found the thread!
This is an example of a good turn signal relocation.
There is a quick write up on how to make them on the 2nd page too.
Comment