Lukebox Sub Dimensions

[itsonlygeorge]

Anyone have one of these they can measure real quick? I'm looking to make something similar but with a cutout for a rear strut bar.

[parkerbink]

I was asked in my thread, here is what I came up with:

Best I can tell with it installed it's height 11" width 35 1/4" depth 10 1/4".

[itsonlygeorge]

I was asked in my thread, here is what I came up with:

Best I can tell with it installed it's height 11" width 35 1/4" depth 10 1/4".

Can you measure the depth of the base, and the depth of the top? trying to figure out the right angle.

 
            ? 
          ____
         |     \
     11  |      \ ?  
         |_______\  <- angle? 
           10 1/4"

[parkerbink]

There is no angle, I'm not pulling it out.

[itsonlygeorge]

Hmm. Looks like that's a different model. I found this thread that lays it out.

https://www.r3vlimited.com/board/showthread.php?t=167321

The outside specs are:
W: 36"
H: 15" (dead nuts on, taller or shorted and you have issues)
Bottom Depth: 10"
Top Depth: 4"

[dubdub]

I do not see how the dimensions would work for you to do a cut out for a bar.

Either the bar will block the height of a box, making it so you cannot push it in... or if you make it to go under the box, you won't have enough height to have a sub point into the cabin.

Good luck, but I'd mock up some cardboard before I tried anything.

[itsonlygeorge]

I think you are right. I think a custom strut bar will work better.


Sent from my iPhone using Tapatalk