analog clock install

[bmw325csi]

did u have the 13 button obc or the basic digital clock? B/C thats exactly how i hooked mine up and it worked fine. My tach and mpg gauge dont work either but thats from my bad SI board.

[abepark]

well I just followed the instructions and now my tach and maybe my speedo don't work, whats up with that? I checked power as well and my clock is still not getting any power.

[MIKe30]

nice, thanks i'll be using that in the near future :)

[JasonC]

I did this not to long ago, but i put everything back together and forgot to write down what wire went to what.

[bmw325csi]

I searched everywhere on the forum and could'nt find a write up on this ( i could be wrong) anywho here it is:

This is for the multi-function clock harness.

Whats needed:
Female power mirror plug
4 butt connectors
wire cutters
wire crimper

Once you remove the mf clock you will see a harness which has about 12 wires, you only need 4. The analog clock has a # above each pin
30-power
31-ground
58k-illumination power
31g-illumination ground

So what you need to do is grab the mf clock harness and cut these wires:
red/white-power
brown-ground
gray/red-illumination power
brown/white-illumination ground

the rest is simple, just connect the wires and bam!

Sorry if i left anything out, this is my first write up, hope this helps some of yall.