HOW TO: Installing IS Side Skirt

[Narsiyousif]

https://photos.flickrprints.com/phot...mfx5ZcW-X5.jpg

[Zoolander090]

I just installed mine last night. This write up was very useful. Thanks

[matias9]

thx for the thread its very useful , i hope can follow your examples , later i ll post my work.

[bernzpeed]

Do these skirts fit on a vert?

sadly no. there is a moulding on the bottom of your side panel.

[Tico Frank]

Do these skirts fit on a vert?

[bernzpeed]

everyone gets them the same place... so NLA.

[PNWDan]

FYI--You can buy from blunt for like $200 including hardware.

http://blunttechclassic.com/

Maybe. Last I heard he had a limited number and had sold them all

[TrentW]

FYI--You can buy from blunt for like $200 including hardware.

http://blunttechclassic.com/

[eur04lif3]

Sorry, for now NO.

Do you have a ET when they might be? I'd be interested in a set.

[bernzpeed]

Is there are group buy for these side skirts?

Sorry, for now NO.

[everhopeful]

Is there are group buy for these side skirts?

[bernzpeed]

Good ideas, guys. It's all a matter of preference.

[PNWDan]

for guys using the 3M tape, how are you prepping the surface? alcohol or grease remover? 3M tape may work with spoilers but something like a side skirt it is prone to impacts into snow, curbs, potholes, debris in the road. Say goodbye to the skirt if it falls off in motion.

Like TrentW said..

Its only holding the top to the body, not holding the entire skirt on. I had to remove my right side once due to having the fender repaired from a guy hitting it. The tape was tough to break loose. Factor in the clips on the pinch seam and its nearly indestructible.

[TrentW]

for guys using the 3M tape, how are you prepping the surface? alcohol or grease remover? 3M tape may work with spoilers but something like a side skirt it is prone to impacts into snow, curbs, potholes, debris in the road. Say goodbye to the skirt if it falls off in motion.

I cleaned mine with denatured alcohol--but why are you bothering asking if you think the tape won't hold?

I since have heard from two others who have used tape and had no issues whatsoever. Besides, I used the two rivets in the rear wheelwell and the plug in the front, and you've got the clips all along the bottom edge, so the tape is really only holding the top edge in the middle of the skirt.

And I don't drive my car in snow, onto curbs, or into potholes. ;)

[CB-M3]

for guys using the 3M tape, how are you prepping the surface? alcohol or grease remover? 3M tape may work with spoilers but something like a side skirt it is prone to impacts into snow, curbs, potholes, debris in the road. Say goodbye to the skirt if it falls off in motion.