god just from seeing this is makin me wanna foll mine this weekend
DIY Fender Rolling...(PICS INSIDE)
Collapse
X
-
im down to try mine with a bat since my paint is shot anyway.
what do you hinge the bat on to get it to rotate in a circular motion? Or do you just improvise?Comment
-
i find rolling the front more difficult since it's thin and hard to start the roll. no matter how careful you do it you will still pull the fender a little. i was trying to avoid this when i did my fenders. you can also cut the roller rubber if you are not careful with your rolling. the rear was easy because it's already half-way rolled from the factory. i heat up the paint really hot from the inside and no paint cracks except for the already cracked paint from my front fender. touched it up, wet sand and it's all good.
some say it's a job for 2 guys but you can do it yourself.Comment
-
Comment
-
i find rolling the front more difficult since it's thin and hard to start the roll. no matter how careful you do it you will still pull the fender a little. i was trying to avoid this when i did my fenders. you can also cut the roller rubber if you are not careful with your rolling. the rear was easy because it's already half-way rolled from the factory. i heat up the paint really hot from the inside and no paint cracks except for the already cracked paint from my front fender. touched it up, wet sand and it's all good.
some say it's a job for 2 guys but you can do it yourself.Comment
-
Rolling with a bat. The result looks terrible.
1992 BMW 525iT Calypso
2011 Jeep WranglerComment
-
Comment
-
http://videos.streetfire.net/video/D...der_139451.htm
Rolling with a bat. The result looks terrible.Need Custom spacers and adapters?
PM for informationComment
-
I've done a few cars with the Eastwood roller, seems that the newer the paint the less likely it is to crack, and if the older paint has been looked after, ( regular waxing etc ) it tends to be a little more flexible.PBMW Magazine. PVW Mag
Fender Rolling for dirt cheap in SoCal.Hit me up.
Check out my work...
http://www.r3vlimited.com/board/showthread.php?t=165114
Comment
Comment