Hey guys, I am in the process of trying to start my car for the first time on this new setup:
M20B25, turbo, stock ignition system (besides plugs), Megasquirt PNP2 with a base tune done by kamotors.
I am not getting any spark from the coil--it has power, but gets REALLY hot after cranking a few times. I bought a new coil and tried today and am getting the same result.
My ignition settings are as follows:
Spark Mode: Toothed wheel
Ignition Input Capture: Falling edge
Spark Output: Going High
Number of coils: Single
Spark A output Pin: IGN 1
Trigger wheel arrangement: Single wheel with missing tooth
Trigger wheel teeth: 60
Missing teeth: 2
Tooth #1 angle: 84.0
Wheel speed: Crank wheel
Using 10 degrees for my cranking advance, as well as 6.0 mS for cranking dwell
I am brand new to MS and Tunerstudio, so I would appreciate any help!
M20B25, turbo, stock ignition system (besides plugs), Megasquirt PNP2 with a base tune done by kamotors.
I am not getting any spark from the coil--it has power, but gets REALLY hot after cranking a few times. I bought a new coil and tried today and am getting the same result.
My ignition settings are as follows:
Spark Mode: Toothed wheel
Ignition Input Capture: Falling edge
Spark Output: Going High
Number of coils: Single
Spark A output Pin: IGN 1
Trigger wheel arrangement: Single wheel with missing tooth
Trigger wheel teeth: 60
Missing teeth: 2
Tooth #1 angle: 84.0
Wheel speed: Crank wheel
Using 10 degrees for my cranking advance, as well as 6.0 mS for cranking dwell
I am brand new to MS and Tunerstudio, so I would appreciate any help!
Comment