I am getting ready to wire in wasted spark. I am using the GM coils and the module board. My MS already have the extra drivers but I am not finding any info on wiring in wasted spark for a MSPNP unit does anyone have info on how they wired theirs up? I know 1 of the wires needs to go to a switch 12v circuit from my understanding but the other three I haven't the slightest clue. I already modified the GM module and got all the stock GM stuff ripped out and the jumper wires installed.
-
1989 325is l 1984 euro 320i l 1970 2002 Racecar
1991 318i 4dr slick top
Euro spec 320i/Alpina B6 3.5 project(the never ending saga)
Vintage race car revival (2002 content)
Mtech 2 turbo restoration
Brilliantrot slick top "build" -
This thread may help you:
https://www.r3vlimited.com/board/for...ption?t=399056
My plan is to put new wires into some of the blank holes on my 55-Pin connector. Here is some info on the connector part numbers (order from digikey or Mouser):
https://www.r3vlimited.com/board/for...rs#post9923800sigpic
1987 - 325i Convertible Delphin Auto [SOLD], 325i Convertible Delphin Manual [SOLD]
1989 - 325i Convertible Bronzit m30b35 swapped [SCRAPPED], 325i Sedan Alpine Auto[DD]
1991 - 325i Coupe Laguna Manual [Project], 535i Sedan Alpine [SCRAPPED] -
Bump. Did you get this sorted?If I didn't start a build thread did the build really happen?
Comment
Comment