If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
What are your guys opinion on this custom setup, will this be a good setup for a chipped motor with 19 pound injectors and a maf?
-Magnaflow 36037 California emissions catalytic converter
-Magnaflow 14416 mini muffler/resonator
-Magnaflow 14579 muffler
The piping is stock size to the catalytic converter, then it increases to 2.5" from the cat to the resonator, then is 2.5" from the resonator to just before the muffler where it is flared to 3". The muffler is 3" in and 3" out with a down/side swept tip. The goal was to make it look close to stock and to keep the noise level down for daily driving. Unfortunately I don't have a sound clip or any footage of the exhaust for you to hear, but it was very close to stock sounding until wide open throttle, where it was slightly louder. There was NO drone at all in any part of the rev range.
My buddy has a very similar setup to that on his m50, with the ebay headers. Sounds like shit, and he knows it. He can't wait to try something else...
Edit: and btw, it is a well known fact that Ireland's catbacks are identical to ebay... I don't know why you need confirmation... That being said, I'm happy with the one I got for free (IE/ebay)
I emailed IE asking about there exhaust and they replied right away about the size. I then asked if it was the same item as the one being sold for a quarter of the price on ebay as the specs are identical. They have not replied in over a few weeks. I wonder if that is a yes?!?
I picked mine up after reading this thread. No packing material so the tips got beat up. The fitment was decent. The sound is all motor now which is pretty nice. Slowed it down just a bit - my old exhaust was completely rusted out so it was like straight pipes lol.
Comment