Turbo M20 Build

[beefjurky69]

Valve cover is back from powder coating...also rear end is just about done made brackets to mount sway bar. I laid the floor out just have to measure out spots for the rivets.

[beefjurky69]

Coil bracket started to get cut last night...


So here's the finished coil bracket one of 2 being made...still needs to be de burred

[IronFreak]

How are you going to wire your coil on plug setup? similar to wasted spark and have 2 fire at the same time?

Also, with adding the 2 vent tubes, are you still going to use the stock one or plug that? Did you put any type of baffling inside the valve cover on those are they just straight through to the catch can? I ask because i an planning out to do something similar.

[beefjurky69]

How are you going to wire your coil on plug setup? similar to wasted spark and have 2 fire at the same time?

Also, with adding the 2 vent tubes, are you still going to use the stock one or plug that? Did you put any type of baffling inside the valve cover on those are they just straight through to the catch can? I ask because i an planning out to do something similar.

Its not gonna get wired as a wasted spark setup...will be wired sequential with the cam sensor added...the VC is using the stock baffles the comes from factory on the VC the original hole will be plugged up.

so maybe different ways of building a catch can that I used a similar setup that a friend of mine came up with lets see if it works. One idea I had was to go right to the oil pan and cure the issue at the source but to that right you would need to drill a hole at the front on the oil pan above oil level. Doing it that way will push oil away from drilled hole under accel. That way the problem never gets to the cyl head.

Its pretty hard to do that set up on an m20 where the accessories are right up front in front of the oil pan so I ended up scratching that idea.

[sayed ali]

Wow damn that coils bracket!

[beefjurky69]

Wow damn that coils bracket!

My buddy Jimmy did a great job designing it...and my other buddies company Montrose Molders is doing the cnc work.

[beefjurky69]

Here's a small video of the cam plate being cut out...
http://youtu.be/fFmXmg7SEzo.

[beefjurky69]

Mounted the coil bracket last night fits pretty good...the smallest spark plug wires I ever had to make.

[Q5Quint]

This reminds me of my ex girlfriend-

completely insane but I love you anyway.

[beefjurky69]

This reminds me of my ex girlfriend-

completely insane but I love you anyway.

Lol too funny...doing work you know

[sayed ali]

Super amazing !!

I'd like to see the wiring plugged in, looks very organized though

[beefjurky69]

Thanks dude...should be wired this weekend or at least that's the plan...cam plate got delivered last night and of coarse I had to install it.

[IronFreak]

What are the two o2 sensors for? Wideband display and tuning?

[beefjurky69]

What are the two o2 sensors for? Wideband display and tuning?

Wideband gauge and one goes to Vems.

[Q5Quint]

Dat cam plate is a beauty- do you just have a magnet on the old rotor or something in there?

Fact: This is a sweet build.
Fact: I am jelly.