turbo E30 wont start, pig rich

[kamotors]

too late I already have the high imp. 30lbers coming in. I can always tune them down a bit with the WAR chip/

[MR 325]

When I first put my car together many many moons ago I tried to run 30lb injectors with Motronic. I could barely get the car around the block. Report back, let me know if it works out for you.

[jaywood]

30lb's work for me. Adjust the afm wheel.

[kamotors]

I will report back with results, my car doesn't have an AFM.^

[jaywood]

My bad! Didn't see that.

My car had the same problem...it wouldn't start when I first put in the new injectors. It took awhile and I had to recharge the battery but eventually it fired up after about 15 tries :(

[MR 325]

My bad! Didn't see that.

My car had the same problem...it wouldn't start when I first put in the new injectors. It took awhile and I had to recharge the battery but eventually it fired up after about 15 tries :(

And you don't think that's a problem? LOL

[jaywood]

My battery was almost dead. Brand new injectors. New fuel lines. After it started up the first time it didn't have trouble starting again. So no, I don't think so ;)

[kamotors]

well, I still haven't received my new injectors even though I paid extra for getting them expedited... But I just read a thread on the other forum that mentioned the TCM dial of the WAR chip not reading the right tune,I ran outside and switched my tune to the #4 position which should of been a tune for 19lb injectors and the car started right up and idled with out me giving it any gas......... it didn't even smoke, as soon as I touched the throttle it died and then my battery died when I tried to restart it. but I'm guessing this means that the TCM was giving the car the wrong tune the whole time:( I still needed new injectors but I'm glad I figured that part out. The thread mentioned position 4 giving tune 1 and it seems to be right on now.

[kamotors]

new injectors fixed it:)

http://www.youtube.com/watch?v=oZ1HSR_7x1I&list=UUJlzn1wjUqI5Co6zrpOACOQ&index=1&feature=plcp

[Zacm829]

Nice, time for a drive!

[brody]

Nice you got it sorted. I didn't even know you had problems, remember you can always email for advice.

Also to those spreading misinformation, you can run 55# injectors on motronic no problem. 24# is way too small for a turbo application too. If you are talking about running X size injectors working without a tune (a size that is not stock) that's just retarded and you might want to look at hogans goat.

[Mr.SWISS]

So I cannot use my 24# gen 3 Ford Racing injectors when I add teh boost?