Sanden a/c compressor in 318i m10?

[alpinewhite318i]

I know this is an old thread, but I wanted to post this just in case it helps anyone. I have a 1985 318i with AC converted to R134a. I am running a Sanden SD5H14 compressor with an AC Solutions fully isolated M10 bracket with bushings. The Sanden compressor and AC Solutions bracket work great together. Good luck!

http://www.sanden.com.sg/opencms/opencms/sites/default/Sanden/_configuration/Catelogue/Product.jsp?pid=1003

https://www.acsolutions.co/products/...0&_ss=e&_v=1.0

I haven't been on here in sometime; thank you for the info. I installed this factory updated m10/s14 a/c bracket, it doesn't use any bushings so there is more vibrations from it. Here is the link to it:

https://www.ecstuning.com/b-genuine-...t/82399404494/

[robertloll1]

I know this is an old thread, but I wanted to post this just in case it helps anyone. I have a 1985 318i with AC converted to R134a. I am running a Sanden SD5H14 compressor with an AC Solutions fully isolated M10 bracket with bushings. The Sanden compressor and AC Solutions bracket work great together. Good luck!

http://www.sanden.com.sg/opencms/opencms/sites/default/Sanden/_configuration/Catelogue/Product.jsp?pid=1003

https://www.acsolutions.co/products/a-c-solutions-bmw-s14-m10-sanden-compressor-bracket-e30-m3-etc?_pos=2&_psq=M10&_ss=e&_v=1.0

[moatilliatta]

Check with bluntech.

Not sure if the 2002 setup would work?



Sent from my iPhone using Tapatalk

[hozzziii]

I also have a Sanden 508 compressor.
Car was fitted an A/C kit from a company called Diavia.
I could post some pictures for you. Would it help?

[jeffnhiscars]

I had a sanden 508 on my M10 and you are on point about the mounting bracket being NLA. That's your challenge

[alpinewhite318i]

Is anyone using an aftermarket Sanden a/c compressor in the m10? Just looking for some thoughts and maybe an idea on how to mount it to the block. I know most aftermarket kits are long gone!